How should the front fork of the head bowl bearing be installed?

In the whole bike technology, understanding the English terminology is very important, after all, in many specifications and technical documents, are shown in English, and the bike five-way bowl set (front bowl set bearings) involves a lot of professional terms, in general the front bowl English is Headset, fork is Fork. specific front bowl set fork how to install it? Follow me to see it together.

Built-in headset bowl set bearing custom products are easy to install, especially on the fork of the bottom gear type open type, can be easily removed in the fork, even if the replacement bowl set or fork are very convenient. And compared to the same grade loose bead type bowl set more durable, built-in bowl set than external type bowl set more solid, will be subject to excessive impact will first prompt the destruction of the bowl set, and thus better maintenance of the head tube position of the frame.

The first thing is to use a rubber hammer to knock the bearing bowl into the head tube, here I took out the bearings inside to knock in independently, in fact, you can knock with the bearings even better, so it is not easy to promote the frame head tube deformation caused by the bearings can not be put in. Of course, if there is a bowl set of professional installation tools will be even better.

Head bowl bearing manufacturer wholesale products in the installation of the fork before the bearings into the bowl, and the bottom stopper installed in accordance with the legend to the fork of the top tube bottom position, and then installed into the frame head tube.

After the fork is installed into the head tube, first note that the bearings in the upper bowl should be installed, followed by the inner washer, then cover the bowl set cover tightly and then set into the required fork gasket, fork gasket according to the specific circumstances of the individual to add the number and specifications.

After the gasket, start to cut the tube, cut the height of the tube is more than the gasket, and more than two-thirds or three-quarters of the length of the structure of the handlebar. After cutting the tube on the core with a screwdriver or something hammered into the fork on the structure of the tube, pay attention to the orientation can not be wrong, the sun flower leaves to be upward.

Group card type head bowl bearing custom products in the installation of the core, put the stand on, but not installed tight, followed by the top cover and core screws, are not installed tight, this is for the next step to install the vehicle to prepare, here, the bowl group and the front fork part even if the installation is complete.

The above is more complete about the front bowl set fork installation, such as there are still questions, please contact us Oh.